Conservation

Where Hunting Happens, Conservation Happens™

Scoring Your Trophy: typical whitetail deer

MINIMUM SCORES
AWARDS: 160
ALL-TIME: 170

All measurements must be made with a 1/4-inch wide flexible steel tape to the nearest one-eighth of an inch. (Note: A flexible steel cable can be used to measure points and main beams only.) Enter fractional figures in eighths, without reduction. For example, if a point measures 7 and 2/8 inches, you would enter 7 2/8 in the space provided.

To be counted a point, the projection must be at least one inch long, with the length exceeding width at one inch or more of length. All points measured from tip of point to nearest edge of beam as illustrated in Figure A. Beam tip is counted as a point, but not measured as a point.
The tip to tip spread is measured between the tips of the main beams.
The greatest spread is measured between perpendiculars at a right angle to the center line of the skull at the widest part, whether across main beams or points. See Figure B.
The inside spread of main beams is measured at a right angle to the center line of the skull at the widest point between main beams. See Figure B. Your Spread Credit will be automatically calculated.
Order
Abnormal points are those non-typical in location (such as points originating from a point or from the bottom or sides of the main beam) or extra points beyond the normal pattern of points. Measure in the usual manner (See Figure A).
The length of the main beam is measured from the center of the lowest outside edge of the burr over the outer side to the most distant point of the main beam. The beginning point is on the burr where the center line along the outer side of the beam intersects the burr, then generally following Line F as shown in Figure C.
Normal points project from the top of the main beam. They are measured from the nearest edge of the main beam over the outer curve to the tip. Lay the tape along the outer curve of the beam so that the top edge of the tape coincides with the top edge of the beam on both sides of the point to determine the baseline for point measurement (See Figure A).
Circumferences are taken at the narrowest place as detailed in Figure C for each measurement. If the brow point is missing, take H-1 and H-2 at the smallest place between the burr and the G-2 point. If the G-4 point is missing, take H-4 halfway between the G-3 point and the tip of the main beam.

Support Conservation

Support Hunting

Support Conservation

Support Education

"The wildlife and its habitat cannot speak. So we must and we will."

-Theodore Roosevelt